Release time：2023-11-08 10:36:19 Hits： Current position: Home > News
This article mainly introduces:
Republic of Lithuania hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder
(Republic of Lithuania unidirectional cylinder,produced by Hengyu Group）
unidirectional cylinder are widely used in Republic of Lithuania，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed unidirectional cylinder for customers from Republic of Lithuania.
If air enters the hydraulic system, the unidirectional cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.
We can not just consider the price and ignore the quality when we purchase the unidirectional cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the unidirectional cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the unidirectional cylinder is not required.
The internal leakage of the unidirectional cylinder is an important indicator to measure the quality of the unidirectional cylinder: the internal leakage of the unidirectional cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the unidirectional cylinder, so that the unidirectional cylinder can not accurately and stably stop in a certain position of the unidirectional cylinder, so it is one of the main indicators of the unidirectional cylinder.
The repair method of the unidirectional cylinder: the repair of the unidirectional cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.
What type of seal is the cylinder of shaft 50?
You won't know the exact model until you take it apart. Oil seals have O, Y, Yx, KYx, U, UN, UHS, YA, St, Gray, Yamagata, Lei type, etc. It is difficult to know what kind of oil seal the designer chooses. Cylinder oil seal installation method: 1. Receive a fixed number of oil seals. 2. From receiving the oil seal to assembly, it must be kept clean. 3. Before assembly, check the oil seal and measure whether the size of each part of the oil seal is consistent with the size of the shaft and cavity. Before the oil seal is installed, the size of the shaft diameter should be clearly compared with the inner diameter of the oil seal. The inner cavity size should be suitable for the outer diameter width of the oil seal. Check the lip of the oil seal for damage.
What is the smallest cylinder size?
The smallest shape cylinder I have ever seen is a hydraulic clamping cylinder in the machine tool industry. Outer diameter 24 mm, total length 23 mm, travel 4 mm. Weighs 0.05 kg. Maximum clamping force 3500 Newtons.
Add Wechat